• Deckorators
  • Home
  • Products
    • Balusters
    • Postcovers
    • Connectors
    • Accessories
    • Virtual Designer
  • Photo Gallery
  • Installation
  • F.A.Q.
  • Media
    • Newspaper
    • Commercial
• Dezigner Fence
  • Home
  • Products
    • Components
    • Fence Style Calculator
  • Photo Gallery
  • Installation/Tools
    • Fence Top Installation
  • F.A.Q.
• Tiger Claw
  • Home
  • Products
    • TC-G Grooved Boards
    • TC-P PVC Fastener
    • TC-1 Softwood Fastener
    • TC-2 Softwood Fastener
    • TC-3 Composite Fastener
    • TC-4 Hardwood Fastener
  • Photo Gallery
  • Installation/Tools
  • Testimonial
  • F.A.Q.
  • Media
• Rot Not
  • Home
  • Products
  • Installation/Tools
  • Testimonial
  • F.A.Q.
• DeckLok
  • Home
  • Products
  • Photo Gallery
  • Installation/Tools
  • F.A.Q.
  • Media
• Kayu
  • Home
  • Products
  • Photo Gallery
  • Installation/Tools
  • F.A.Q.
  • Media
• Underdeck
  • Home
  • Products
  • Photo Gallery
  • Installation/Tools
  • F.A.Q.
  • Media
• Deck Screws
• Post Caps
  • Home
  • Products
  • Tiffany-Style Post Caps
  • Wood Post Caps
  • Metal Post Caps
  • Photo Gallery
  • Installation/Tools
  • F.A.Q.
  • Media
• Oz-Post
  • Products
  • Fence Brackets
  • Instant Post Holes
  • Deck Foundation System
  • Tools
  • Oz-Puller
  • Deck Rail Anchor System
  • Photo Gallery
  • Oz-Post
  • Oz-Deck
  • Oz-Railing
  • Installation/Tools
  • F.A.Q.
  • Media

 Dezigner Installation

Fence top lattice replacement using components

Preassembled sections also, see Fence Style Calculator for more details

Download our Fence Panel Assembly Instructions.

	1: Centre flex-rail between posts s that there is 2-3 inches from post to first hole. Mark and cut rail.
	2: Centre flex-rail between posts s that there is 2-3 inches from post to first hole. Mark and cut rail.
	3: Place flex rail on fence top and use holes to mark location of Deckorators baluster connector
	4: Screw down baluster connectors to top of fence
	5: Install flex rail connector on the pickets at approximately 1/3 and 2/3 of the rail length. Use a # 6 x 1/2 inch screw and position flexrail connector 1.75 inch down from the top of the picket
	6: Click picket into place and pull down on ends to desired curve. Insert rail end connector and screw into place
	7: Measure distance from fence top to top of flex rail and add approx. 1.75 inches. Cut all tubes for each location and put into position.
	8: Slip a flex rail connector onto each baluster and then click into place with screwdriver or awl
	9: Screw flex rail connector to the balusters
	10: Install spears and screw into place